• Safety Instruction

1. The industrial gate operator should be installed and put into operation by qualified personnel. Otherwise, serious personal injury or property damage may occur.

2. Installation and wiring must be in accordance with the construction standards and electrical standards, diameter ≧ 1.5mm2 ; power must have a reliable grounding, ground wire must be reliably connected to the place labeled ground tab, ground lead on the power line is prohibited to be removed; front end of incoming power line should be installed with electrical leakage protector which is in line with national standards.

3. This industrial gate operator is only allowed to be installed on well-balanced gate which has balance spring, otherwise machine may be damaged due to overload.

4. Gate should be flexible and run without stagnation; lead rail end of gate must be installed with mechanical stop block and buffering booster to prevent the gate from rolling out.

5. Control box should be installed in the wall or column of 1.4 meters where the operation of gate can be observed to prevent children from inadvertently touching. While keeping the remote control, prohibit children to touch or play just in case of danger. Do not use the remote control when you cannot see the operation of gate.

6. Before repairing and moving the gate machine and control box, please cut off the power supply, and make sure that the gate has been locked and the risk of falling due to self-weight is null.

7. Pedestrian and vehicle are prohibited to go through or stay below the running gate.

8. Hand-pulled chain on the machine is prohibited to be pulled during the operation of gate machine to prevent the machine from damage.

9. To ensure the safety of pedestrian and vehicle, please install the infrared protection device and airbag protection device

10. Relevant safety protection devices and the operation of the gate should be checked frequently to ensure the security and stability of gate.

• Technical Characteristics